This article first appeared in Electric Bike Report in June of 2013. Since then, we’ve made some changes to our motor selection - our Direct-Drive motors are now all High-Torque 6x9 wound, so they run slower (approximately 15mph at 36v or 20mph at 48v), and our Geared Motors have been replaced by a 500w version, (approximately 20mph at 36v or 28mph at 48v). The Direct-Drive is now our Heavy-Duty motor and the...
I took my new Pedego Ridge Rider for my first ride today – a 25 mile single track trail. I have been riding all my life and knee pain ended my daily club rides one year after retiring. My Ridge Rider makes me feel like a Titan! I have a mountain bike that was more expensive than the Ridge Rider and I must say that the Ridge Rider rivals or exceeds the quality and ride “feel” on my non-electric mountain bike (which I can no longer ride due to the extreme pain it creates on my knee). The Ridge Rider provided 100% joy and 0% pain. What can be better! The Ridge Rider is a no compromise bike with great running gear and amazing battery life. I rode 13 miles on assist level 3 and about 12 miles on assist level 4 and made it home with 15% battery life even though the temperature was about 43 degrees F. This is the best purchase I have ever made. I second all the other reviews. This is a fabulous bike supported by a fabulous manufacturer. I can’t give enough praise to Fitness Central in Schnecksville, PA. The owner and staff gave me better advice and attention than I could have hoped for. Thanks to one and all!
Written by Gaston Daigle. Gaston is an admin and key contributor at the popular Endless Sphere Technology Forum Batteries and battery packs, the lifeblood of your electric bicycle Plug and play?... not always that easy and certainly not very simple for most of us.. or is it? A good Lithium battery pack can cost as much, and often even more than the rest of your electric bike kit. Picking the right...
Though aside from the extra battery and abundance of included accessories, Riese and Muller’s use of a Gate’s belt drive means no shifting of gears, no greasy maintenance, and much higher durability. If you have the money to spend, Riese and Muller’s Delite nuvinci is one of the best on the market and an ebike we just couldn’t get enough of during our own tests.
Motorcycle manufacturer KTM has long produced bicycles too, but it is in the e-MTB category that the brand’s heritage is really employed. Motocross fans and riders looking to get into e-MTB riding will appreciate KTM’s decision to use a ‘precise’ 29er front wheel and ‘traction rich’ 27.5-Plus rear wheel (MX bikes also feature different front/rear wheel sizing), an approach some other manufacturers have also adopted (e.g. Canyon). The bike is adorned with a solid build kit including e-MTB-specific parts like SRAM’s EX1 drivetrain.
While this set off some excitement among Tesla watchers who also love two-wheelers, it’s much more likely that any e-bike that emerges will be a limited production run, Tesla-branded bike built with one of many great e-bike companies in California. Like the Tesla carbon-fiber surfboard or the Boring Company Flamethrower, it would provide excellent press, be offered at a high price point, sell instantly and be even more good marketing for Tesla. It might be a folder designed for the Model S frunk or other niches on the Model 3 or X. On the other hand, e-bikes are becoming a high-volume, global business and Tesla is well positioned with global retail space, excellent access to batteries, and big factories to get around for its staff. There might be a permanent product in place. Regardless, a dozen e-bike manufacturer CEOs undoubtedly picked up their smart phones and tried to get through to Musk or his execs immediately to offer their services.
On the AM 4 you get 150mm of travel via a Fox Factory 36 Float fork, 11-speeds from a Shimano Deore XT drivetrain, and Magura MT-Trail hydraulic disc brakes. They also don’t gip you on the dropper with a wonderful, wonderful KS Lev. In terms of geometry, the build is pretty dope. It’s a nice slack feel, so you can do some solid downhills. A DT Swiss wheelset along with Magic Mary tires give you a lightweight and smooth ride.
The sub has been awesome in giving me confidence, I got a Giant XTC from CL. and was going to order all the parts from Luna's Black Friday Sale. A couple of questions, I will have a bike shop remove the bottom bracket, but I am assuming the Bafang 750 with the 17 AH battery should be an easy install at that point (or is it)? I am thinking of having the bike shop install the motor too and I do the the rest. besides a pedal crank, Allen wrenches etc, what tools will I need? Any top rated videos to watch? Is the speed sensor worth it? What about the half twist vs. full twist vs thumb throttle? Color display,, etc. Since the bike has a 10-speed cassette, will that be good or bad (me thinks good). Any other thoughts or pointers? Should I order the stuff from Aliexpress or Ebay?
More powerful pedelecs which are not legally classed as bicycles are dubbed S-Pedelecs (short for Schnell-Pedelecs, i.e. Speedy-Pedelecs) in Germany. These have a motor more powerful than 250 watts and less limited, or unlimited, pedal-assist, i.e. the motor does not stop assisting the rider once 25 km/h has been reached. S-Pedelec class e-bikes are therefore usually classified as mopeds or motorcycles rather than as bicycles and therefore may (depending on the jurisdiction) need to be registered and insured, the rider may need some sort of driver's license (either car or motorcycle) and motorcycle helmets may have to be worn. In the United States, many states have adopted S-Pedelecs into the Class 3 category. Class 3 ebikes are limited to <=750 watts of power and 28 mph.
There are various kinds and classifications of electric bikes on the market, but the more common type is the Class 1, or pedal assist, bikes which have motor units that are activated by pedaling and are limited to lower speeds. In the US, Class 1 electric bikes, the type tested and reviewed here, are limited to a top speed of 20 mph and their motors are designed with a speed governor to regulate this. These types of e-bikes resemble modern mountain bikes, but they have significant battery packs and small motor units integrated onto and into the frame design. The e-MTB pedal-assist motor is typically built around the bottom bracket and provides varying levels of pedaling "support" directly into the drivetrain while the cranks are turning. Most drive unit systems offer several support settings that provide pedal assistance between 25% and 100% of the user's pedaling input.
Back Alibi Allez Allez Junior Amira Ariel AWOL Camber Chisel Crossroads Crosstrail CruX Demo Diverge Dolce Enduro Epic Hardtail Epic Fatboy Kids' Fat Bikes Fuse Hotrock Langster Pitch P.Series Riprock Rockhopper Roll Roubaix Ruby Ruze Sequoia Shiv Sirrus Stumpjumper Shiv TT Tarmac Turbo Como Turbo Kenevo Turbo Levo FSR Turbo Kenevo Turbo Vado Venge
On the 8.0 specifically, Haibike sets you up with the brand new Yamaha PW-X motor. This motor comes standard with a 500 watt hour battery, Bluetooth connectivity, and 80 nm of torque out the gate. The PW-X also boasts the benefit of a dual chainring up front. This means you’ll save some battery if you’re willing to work a little harder and use those gears! Speaking of gears, you’ll get a Shimano Deore XT drivetrain. Pair that with Fox 34 Float Performance front suspension and a Fox Float DPS rear shock (150mm travel) and you’ve got a fully-capable, all-around ride.
“I’d like a Bosch bike!” This is what bicycle dealers hear several times a day from new customers – and it’s the biggest mistake you can make when buying an ebike. Sure, the motor is important. However, you don’t buy a car just because of its engine. If you want to be happy with your eMTB in the long term, you have to consider a bike as an overall concept. This group test will help you to find out which bike is best for which type of rider, terrain, and riding style. The motors of the big names in the industry all work extremely well, but differ in their purpose and functionality.
The seat is a long, tapering bench-style saddle common to this genre of e-bike. The design allows the same size frame to fit multiple sized riders. While it’s not quite the same as having a fully adjustable frame, e-bikes don’t require the same precision fitment due to their electric assist. When you’re using the bike like a motorcycle, you just kind of sit wherever is comfortable.
Not all e-bikes take the form of conventional push-bikes with an incorporated motor, such as the Cytronex bicycles which use a small battery disguised as a water bottle. Some are designed to take the appearance of low capacity motorcycles, but smaller in size and consisting of an electric motor rather than a petrol engine. For example, the Sakura e-bike incorporates a 200 W motor found on standard e-bikes, but also includes plastic cladding, front and rear lights, and a speedometer. It is styled as a modern moped, and is often mistaken for one.
Torque sensors and power controls were developed in the late 1990s. For example, Takada Yutky of Japan filed a patent in 1997 for such a device. In 1992 Vector Services Limited offered and sold an e-bike dubbed Zike. The bicycle included NiCd batteries that were built into a frame member and included an 850 g permanent-magnet motor. Despite the Zike, in 1992 hardly any commercial e-bikes were available.