China has experienced an explosive growth of sales of non-assisted e-bikes including scooter type, with annual sales jumping from 56,000 units in 1998 to over 21 million in 2008, and reaching an estimated fleet of 120 million e-bikes in early 2010. This boom was triggered by Chinese local governments' efforts to restrict motorcycles in city centers to avoid traffic disruption and accidents. By late 2009 motorcycles are banned or restricted in over ninety major Chinese cities. Users began replacing traditional bicycles and motorcycles and e-bike became an alternative to commuting by car. Nevertheless, road safety concerns continue as around 2,500 e-bike related deaths were registered in 2007. By late 2009 ten cities had also banned or imposed restrictions on e-bikes on the same grounds as motorcycles. Among these cities were Guangzhou, Shenzhen, Changsha, Foshan, Changzhou, and Dongguang.
Both land management regulators and mountain bike trail access advocates have argued for bans of electric bicycles on outdoor trails that are accessible to mountain bikes, citing potential safety hazards as well as the potential for electric bikes to damage trails. A study conducted by the International Mountain Bicycling Association, however, found that the physical impacts of low-powered pedal-assist electric mountain bikes may be similar to traditional mountain bikes.
The harder you pedal, the bigger the boost, the faster you’ll ride—to a point. E-bikes let you hum along at a brisk clip, but they aren’t motorcycles. You’ll never jackhammer down the road at 45 mph. The motor is governed to stop propelling you further when you hit 20-28 mph, depending on the bike. So you’ll save time on your commute (I shave about three minutes off a five-mile trip) but still enjoy the scenery.
In addition to the pedal-assist feature, some e-bikes come with a throttle that engages the motor with the press of a button. These belong to a separate class of e-bike that, obviously, doesn’t offer a pure cycling experience; they’re also illegal in some municipalities. Interestingly, Benjamin says, people who aren’t already “cyclists” tend to gravitate toward throttle bikes at first, but then turn around and choose a pedal-assist for their next purchase.
I'm looking to leverage the Cycle to Work Scheme and have been looking around for an e-bike to purchase. I used a lot of the information provided here and have come to the conclusion that the Kreiger from Woosh meets all my needs. 95% of the time the bike will be used to commute to and from work, the rest of the time I'll probably be rising it around the park with the kids. The thing I like about this bike is that it pretty much comes with everything (except the lock) that you'd need to get going. I guess, if I really wanted to, I could upgrade the Bafang motor on this to a BBS02 with a better battery.
Often times, carbon gets all of the attention, but as our Senior Advanced R&D Engineer, Chuck Teixeira, says, 'If you haven't ridden an aluminum bike lately, you haven't ridden an aluminum bike.' And the same reigns true for the Men's Chisel. It packs some serious XC-prowess into an aluminum frame, making it the most durable, value-packed XC bike out there.
World Championships, Olympic Gold, more Cape Epic wins than we can count—if a bike were the sum of its accolades, the Epic would sit atop the throne. And to make sure of it, our new Epic features a completely re-designed frame, geometry, and a totally new Brain rear shock that's engineered to read the terrain for the most efficient ride possible, making it the fastest XC bike on the planet.
Not all e-bikes take the form of conventional push-bikes with an incorporated motor, such as the Cytronex bicycles which use a small battery disguised as a water bottle. Some are designed to take the appearance of low capacity motorcycles, but smaller in size and consisting of an electric motor rather than a petrol engine. For example, the Sakura e-bike incorporates a 200 W motor found on standard e-bikes, but also includes plastic cladding, front and rear lights, and a speedometer. It is styled as a modern moped, and is often mistaken for one.
The two most common types of hub motors used in electric bicycles are brushed and brushless. Many configurations are available, varying in cost and complexity; direct-drive and geared motor units are both used. An electric power-assist system may be added to almost any pedal cycle using chain drive, belt drive, hub motors or friction drive. BLDC hub motors are a common modern design. The motor is built into the wheel hub itself, and the stator fixed solidly to the axle, and the magnets attached to and rotating with the wheel. The bicycle wheel hub is the motor. The power levels of motors used are influenced by available legal categories and are often, but not always limited to under 750 watts.
After 2 months of online research and talking to people that owned e-bikes I walked into the Glendale, Arizona Pedego store. I met the owners Sherry and Steve. They suggested I try the Ridge Rider as it might be a fit for me. I test rode it for about 45 minutes to an hour and was somewhat convinced this could be the bike for me. I went home and did more research on the Ridge Rider. After careful thought I decided to purchase one the next day. Since then Steve, the owner, has worked with me to personalize my bike so that it is as comfortable on the trails as it is on the road. I cannot say enough about the after sale experience I have received from Sherry and Steve. I would recommend them and their store to anyone interested in an e-bike.
All models of the Turbo Levo use a frame made from M5 aluminum alloy, with the motor and removable battery integrated inside. The frame and fork use 148mm (rear) and 110mm (front) spacing. Specialized 6Fattie Purgatory (front) and Ground Control (rear) 3-inch wide tires are laced to 38mm Roval Traverse rims. Rear stays and pivots are beefed up to handle the additional weight (48.5 lbs) and torque, and bridges are added to the stays, over the non-motorized Stumpjumper. The front fork is a RockShox Yari XC with a 15mm thru-axle. The 135mm rear travel is provided by a custom Fox Float Performance DPS shock with automatic sag adjust.
In the year 1885, a British man named J.K. Stanley introduced what can fairly be described as the first modern bicycle. His Rover bike had wheels of equal size in the front and back and used a chain connecting the pedals and the rear wheel as a propulsion system. It was often marketed as a safety bike in contrast with the unstable Penny Farthing, and was a smashing success. The company went on to develop motorcycles and automobiles, remaining in business until the year 2005.
By 1898 a rear-wheel drive electric bicycle, which used a driving belt along the outside edge of the wheel, was patented by Mathew J. Steffens. Also, the 1899 U.S. Patent 627,066 by John Schnepf depicted a rear-wheel friction “roller-wheel” style drive electric bicycle. Schnepf's invention was later re-examined and expanded in 1969 by G.A. Wood Jr. with his U.S. Patent 3,431,994. Wood’s device used 4 fractional horsepower motors; connected through a series of gears.